There’s some good news to older homes with plaster ceilings. Did you know that it can still be repaired? plaster ceilings can still recover from getting further damaged. Most of the old ceilings were effectively reconnected by adding adhesives between the plaster and lath, and here is where it deteriorates over time.  

While the repair technique used for plaster differs from new ones, it is still effective. The use of modern materials is what makes it work. They’re also easy to handle and cause minimal sound damage. The use of the right techniques and correct tools allow plaster ceilings to be maintained for many years to come. 

How to Repair Plaster Ceilings 

If your plaster ceiling is damaged, here are some of the steps that need to be done to have it repaired. It’s important that you hire the experts in plaster repair New Jersey because only the professionals can get things done the right way.  

1. Check the condition of the ceiling.  

To fix the problem, your ceiling has to be loosened first. So, you’ll immediately see if you have a leaky roof or if you need to do some structural changes to it. The first step is to decide how far you’re willing to repair the ceiling. Slowly move the surface and determine the quantity between the plaster and the lath. Luckily, doing that feels like moving a piece of puzzle that will slip back into its own unique place.  

2. Check for a possible reinstallation work. 

Reinstallation may not be an option unless the damage is extensive. If you find that the worst part of the ceiling requires a lot of effort to repair, then you might have to reconsider if you still want to use plater for that. There are other materials that can be used instead and they’re cheaper and easier to maintain.  

3. Locate the wood laths.  

In case repair is feasible, the next step is to find the wood laths. The holes that you drill for injection must be directly under the wood lath and not between them. That way, the adhesive sticks to something solid. You can see the lath position after removing the plaster or after digging a gap.   

4. Drill injection holes.  

It’s a challenge to make these holes because it is very important that you only drill through the injection surface. When connecting from the plaster side, you have to drill through the plaster completely, but stop before you reach the wood lath. 

5. Secure the plaster.  

Now that the adhesive is well in place, it’s time to push the plaster back into its original slot. Place it securely against the lath using forms. Doing so allows the adhesive to full bond into the surface area.  

6. Remove the forms.  

After a day, the plaster should have set and ready. It’s time to remove the forms. Some of the plastic will stick to the injected adhesive so be prepared for that. Simply scrape that off using a putty knife. Plaster repair is a process that not all of today’s contractors can do. Be sure to hire somebody who is experienced with the job.